Reboot InfiniTV 6ETH remotely?
Forum rules
Ceton no longer participate in this forum. Official support may still be handled via the Ceton Ticket system.
Ceton no longer participate in this forum. Official support may still be handled via the Ceton Ticket system.
- woodchuck
- Posts: 338
- Joined: Tue Jun 14, 2011 9:43 pm
- Location:
- HTPC Specs:
Reboot InfiniTV 6ETH remotely?
Is it possible to initiate a reboot of the ETH6 via it's web interface or similar? I'm on the road and cannot "pull the plug". I am seeing an error in the diagnostics tool, and wanted to see if rebooting the ETH would help. Rebooting the HTPC did not.
-
- Posts: 786
- Joined: Fri Jul 20, 2012 7:23 pm
- Location:
- HTPC Specs:
Don't have a ETH but all the other tuners you can do this if you can get to the web gui, click on LOG and then at the bottom type in "REBOOT" and hit enter. You then need to close the web gui and wait a few seconds and re-open it and the update will be at a few seconds and the cableCARD will be rebooting. This will not restart a TA if your problems are TA related (and often are) and the TA needs a power cycle to re-establish up and downstream connections, load a new configuration file, channel map and authorize the resolver.
-
- Posts: 29
- Joined: Thu Jan 24, 2013 12:58 pm
- Location: Indianapolis, IN
- HTPC Specs:
I couldn't get this to work with the latest beta firmware.. It says commands are disabled.JohnW248 wrote:Don't have a ETH but all the other tuners you can do this if you can get to the web gui, click on LOG and then at the bottom type in "REBOOT" and hit enter. You then need to close the web gui and wait a few seconds and re-open it and the update will be at a few seconds and the cableCARD will be rebooting. This will not restart a TA if your problems are TA related (and often are) and the TA needs a power cycle to re-establish up and downstream connections, load a new configuration file, channel map and authorize the resolver.
-Greg
- woodchuck
- Posts: 338
- Joined: Tue Jun 14, 2011 9:43 pm
- Location:
- HTPC Specs:
Same here. Latest beta f/w for me too...gthompson20 wrote:I couldn't get this to work with the latest beta firmware.. It says commands are disabled.
-
- Posts: 1378
- Joined: Mon Aug 22, 2011 9:23 pm
- Location:
- HTPC Specs:
try "reboot" in lower case. It should still be in our latest beta firmware.
Quality Assurance Manager, Ceton Corporation
- woodchuck
- Posts: 338
- Joined: Tue Jun 14, 2011 9:43 pm
- Location:
- HTPC Specs:
That seems to have worked. Thanks erkotz!
-
- Posts: 1378
- Joined: Mon Aug 22, 2011 9:23 pm
- Location:
- HTPC Specs:
FYI I'm not certain who/where the uppercase commands originated from, but the command has never been supported in upper-case in any firmware, so if you see that somewhere, it's wrong.woodchuck wrote:That seems to have worked. Thanks erkotz!
Quality Assurance Manager, Ceton Corporation