Removing a tuner
Posted: Fri Aug 02, 2019 4:50 pm
I had a tuner go bad, and would like to remove it, without editing the tuner sources for all the channels individually. I need to preserve the recording schedule. They are all for Series recordings that are set to Any Channel.
From my experiments on a test system, the following is the way to go:
Physically unplug the tuner (Its a HDHomerun).
Without doing a Clean Start, run Setup TV Signal, not agreeing to the Guide Data TOS.
Run EPG123, an do a Save & Execute.
Run EPG123Client, and remap the Lineup Services to the Guide Channels.
Is this the correct way to go? Do I need to reapply the Increase tuner limit tweak somewhere?
Thanks
.
From my experiments on a test system, the following is the way to go:
Physically unplug the tuner (Its a HDHomerun).
Without doing a Clean Start, run Setup TV Signal, not agreeing to the Guide Data TOS.
Run EPG123, an do a Save & Execute.
Run EPG123Client, and remap the Lineup Services to the Guide Channels.
Is this the correct way to go? Do I need to reapply the Increase tuner limit tweak somewhere?
Thanks
.