Page 1 of 1

epg123 latest upgrade

Posted: Sat Aug 12, 2017 5:13 pm
by sgeeks
Garyan2 when doing the new update do you have to start all over from scratch or does it keep all my settings when I run it?

Thanks,
Tom

Re: epg123 latest upgrade

Posted: Sat Aug 12, 2017 7:05 pm
by garyan2
Just need to run the installer. It will copy over the existing epg123 program files and leave the epg123.cfg file alone which contains all your settings.

Re: epg123 latest upgrade

Posted: Mon Aug 14, 2017 10:34 pm
by newfiend
Gary,
Are there any steps that need to be taken after updating from a previous version? Clear Cache then save and execute again etc.??
The reason I am asking is I have updated a couple times since my original installation. There have been some issues with my HTPC and Ceton InfiniTV6 loosing the tuners lately and I am getting recording conflicts when numerous other tuners should have been available and some recordings displaying the Weak TV Signal screen in WMC.

As a side note I have also been getting Kernel power errors lately in event viewer as well. I just started a ticket with Corsair to replace the PSU. I am not sure if the problems I am having are due to not updating EPG123 correctly step wise post update or if the Kernel Power and PSU are causing my current issues.
I don't mean to hijack the OP's thread but I thought I would ask in case there are certain steps I should be taking post updating EPG123.
Thanks,
newfiend~

Re: epg123 latest upgrade

Posted: Tue Aug 15, 2017 12:23 am
by garyan2
Nothing special. Except for 1 instance of upgrading 1.0.2 and below to a 1.1.x version, all updates have only required copying over the existing .exe files. All cache, config, and xml file are backwards and forwards compatible.

Re: epg123 latest upgrade

Posted: Wed Aug 16, 2017 12:21 am
by newfiend
Thanks for the reply Gary.
I will switch out the PSU and see how it goes from there.
Loving EPG123 so far.. Thank you!!
newfiend~