Playback Software for Frame Packed 3D MVC / mkv with remote?
-
- Posts: 1708
- Joined: Fri Aug 24, 2012 7:35 pm
- Location:
- HTPC Specs:
Playback Software for Frame Packed 3D MVC / mkv with remote?
Is there such an animal? Are there any links to setting it up in WMC / EMC?
-
- Posts: 1477
- Joined: Mon Aug 20, 2012 6:52 pm
- Location:
- HTPC Specs:
Not sure, but I think PotPlayer would be worth a try. It also has pretty good remote config tools. It would not run inside WMC or Emby (I don't know what EMC is).
-
- Posts: 1708
- Joined: Fri Aug 24, 2012 7:35 pm
- Location:
- HTPC Specs:
EMC = Emby for WMC or Emby Windows Media Center Classic..
So, you cannot set the EMC Configurator to load PotPlayer for mkv's with 3D tagging in the file name?
So, you cannot set the EMC Configurator to load PotPlayer for mkv's with 3D tagging in the file name?
Last edited by Sammy2 on Wed Jan 06, 2016 5:47 pm, edited 1 time in total.
-
- Posts: 1477
- Joined: Mon Aug 20, 2012 6:52 pm
- Location:
- HTPC Specs:
Maybe you can. I know nothing about EMC. Sounds like it might work.
-
- Posts: 1708
- Joined: Fri Aug 24, 2012 7:35 pm
- Location:
- HTPC Specs:
I shall give it a whirl..
Are you using it? Do you have a link to setting it up for using a remote? I looked at the PotPlayer Forum and didn't see any mention of it.
Are you using it? Do you have a link to setting it up for using a remote? I looked at the PotPlayer Forum and didn't see any mention of it.
-
- Posts: 1477
- Joined: Mon Aug 20, 2012 6:52 pm
- Location:
- HTPC Specs:
I've used it in the past with a remote. As I recall, there is a place to map keystrokes to functions. You just have to know what keyboard equivalents MCE sends. I don't know off the top of my head, but I think I found a cross reference on some XBMC wiki. I know that's not a lot to go on, but I'm pretty much out of the HTPC game now. If I remember or dig up anything else, I'll post it.
-
- Posts: 1477
- Joined: Mon Aug 20, 2012 6:52 pm
- Location:
- HTPC Specs:
Following up. I think you could use something like this, then do matching mapping on the PotPlayer side. Back when I did it, I didn't have to change much to get it to work, possibly just the ffwd/rew functions.
http://forum.kodi.tv/showthread.php?tid=164252
There was another thread about using a remote with PotPlayer on this board not too long ago. That user had pretty good success too.
http://forum.kodi.tv/showthread.php?tid=164252
There was another thread about using a remote with PotPlayer on this board not too long ago. That user had pretty good success too.