Tuner Not Found error during TV setup

[JackatForum]

After getting a replacement INFINITV for intermittant problems I now cannot get anything connected to WMC.

The CETON diagonostics are all green.

When I try to configure WMC i get TUNER NOT FOUND in Set Up TV Signal.

Win 7/64 pro, no extendes, just 1 PC, 1 Infinitv, 1 TV.

HELP

[newfiend]

Open the Ceton Diagnostic Utility
On one of the Tabs are three button options all on the same tab, Clear network configuration Button, Clear Tuner Configuration button, and a Discover tuners button.
Start by Clearing the Network Configuration (you may have to reboot after doing so, if so reopen the Diagnostic utility again and do the following steps)
Then clear the Tuner Configuration
Then Rediscover the Tuners
After it completes (it takes a few seconds to do this) Close the Ceton Diagnostic Utility.
Open Media Center >Tasks/Settings and run through setting up the TV Signal again.
HTH,
newfiend~

[JackatForum]

Yep that worked! Thanks. But with all this my intermittant Subscription Required messages persist. Back to calling Bright House Networks.

[Dkeyguy1]

Yep that worked! Thanks. But with all this my intermittant Subscription Required messages persist. Back to calling Bright House Networks.

I had some of that for a while when on the last beta firmware, but reverted to the last stable and is fine now.
Then the cable went out.......
for every action..........