Ceton signal strength issue?
Forum rules
Ceton no longer participate in this forum. Official support may still be handled via the Ceton Ticket system.
Ceton no longer participate in this forum. Official support may still be handled via the Ceton Ticket system.
- newfiend
- Posts: 2503
- Joined: Tue Jun 07, 2011 12:10 pm
- Location: Earth
- HTPC Specs:
Ceton signal strength issue?
I am getting heavy macroblocking on HBO the tuner states signal level -27.8 dBmV and signal to noise level 27.4 dB
I am assuming I need to get Comcast out to fix my signal levels.. Am I correct?
Sent from my WP7 using Board Express
I am assuming I need to get Comcast out to fix my signal levels.. Am I correct?
Sent from my WP7 using Board Express
-
- Posts: 2623
- Joined: Wed Jun 08, 2011 3:15 am
- Location:
- HTPC Specs:
If you haven't changed anything else, I'd say it's the line. -27.8 dB is WAY too low.
- newfiend
- Posts: 2503
- Joined: Tue Jun 07, 2011 12:10 pm
- Location: Earth
- HTPC Specs:
Thats what I thought as well. I just read over here http://www.cetoncorp.com/support/index. ... -explainedrichard1980 wrote:If you haven't changed anything else, I'd say it's the line. -27.8 dB is WAY too low.
about SNR.. I then got in a chat w/Comcast and they are coming out Thursday.
Thanks for the reply Richard.. I feel better knowing I did the right thing.
Edit: On a side note..
Our cable comes into the house to what I would guess is a huge Splitter. Every room is wired for Cable in the house. Would suggesting a Amp on the line help in this situation? Currently I am only using one Coaxial connection (Livingroom) and that is split between 2 Ceton Tuners and a cable modem (3 way splitter). Mikinho also suggested I use cable terminators on the lines that aren't used..
newfiend~
-
- Posts: 5738
- Joined: Tue Jun 21, 2011 7:23 pm
- Location: Titusville, Florida, USA
- HTPC Specs:
Newfiend,
If you aren't using a coax connection, and you don't plan to use it in the near future, the first thing to do would be to install a smaller splitter (or fewer splitters) and disconnect those rooms.
Installing terminators on un-used lines is recommended if you do not disconnect them as recommended above. The terminators reduce reflected signals and signal/noise injection. Noise injection is when the open cable outlets receive radio frequency signals from signals in the air (from things like television/radio transmitters, wireless devices, microwave ovens, etc).
Finally, installing an amplifier can help, but only if the signal coming into the amplifier is clean to begin with. If there is noise on the line coming into the house, the amplifier will amplify the noise just as much as it amplifies the signal.
In any case, the tech should check the line coming from the utility pole (or box, if you have underground service) to make sure that the connections are clean, tight and not corroded, and that water intrusion is not a problem.
If you aren't using a coax connection, and you don't plan to use it in the near future, the first thing to do would be to install a smaller splitter (or fewer splitters) and disconnect those rooms.
Installing terminators on un-used lines is recommended if you do not disconnect them as recommended above. The terminators reduce reflected signals and signal/noise injection. Noise injection is when the open cable outlets receive radio frequency signals from signals in the air (from things like television/radio transmitters, wireless devices, microwave ovens, etc).
Finally, installing an amplifier can help, but only if the signal coming into the amplifier is clean to begin with. If there is noise on the line coming into the house, the amplifier will amplify the noise just as much as it amplifies the signal.
In any case, the tech should check the line coming from the utility pole (or box, if you have underground service) to make sure that the connections are clean, tight and not corroded, and that water intrusion is not a problem.
- newfiend
- Posts: 2503
- Joined: Tue Jun 07, 2011 12:10 pm
- Location: Earth
- HTPC Specs:
Thanks guys.. Appreciate the input!
Sent from my WP7 using Board Express
Sent from my WP7 using Board Express
- newfiend
- Posts: 2503
- Joined: Tue Jun 07, 2011 12:10 pm
- Location: Earth
- HTPC Specs:
Ok, finally after a missed apt. By Comcast, the wife complaining about having to empty a closet so the cable guy could remove a splitter twice etc.. I finally have good signal strength @-2dB /38. I am hoping picture quality takes a little jump for the better! We'll see tonight.
Sent from my WP7 using Board Express
Sent from my WP7 using Board Express
-
- Posts: 1
- Joined: Mon Jul 08, 2013 12:21 am
- Location:
- HTPC Specs:
I've been having this problem a lot recently and it's driven me nuts. Only one person knew to send the authorization codes. Today I found out that it wasn't necessary at all. Here's what I did....
I checked the diagnostics to see what the SNR and signal differences were between a working channel and a non-working channel (same package). They were almost exactly the same (~-15 Signal and 15 SNR). After seeing that "perfect" would be 0 / 30 I decided to check my connections. They were all fine so I reseated the Ceton cable. Instantly my readings changed to -14/36 and channels started coming in. We had a Comcast outage yesterday and my guess is that they forgot to "repush" the cable cards and just did the DVRs or whatever.
For Congress having passed a law that says we must be allowed to use these devices it certainly doesn't feel like Comcast cares about that law.
Best of luck to you all.
I checked the diagnostics to see what the SNR and signal differences were between a working channel and a non-working channel (same package). They were almost exactly the same (~-15 Signal and 15 SNR). After seeing that "perfect" would be 0 / 30 I decided to check my connections. They were all fine so I reseated the Ceton cable. Instantly my readings changed to -14/36 and channels started coming in. We had a Comcast outage yesterday and my guess is that they forgot to "repush" the cable cards and just did the DVRs or whatever.
For Congress having passed a law that says we must be allowed to use these devices it certainly doesn't feel like Comcast cares about that law.
Best of luck to you all.