rem In the script below, the %1 represents the tuner device (%DEVICE%) name
rem passed from Hauppage Setup. The %2 represents the channel (%CHANNEL%) value passed
rem from WMC.
rem Both values used as arguments to the executable batch file
rem Each device must be assigned to an IP address
if %CURDEVICE% EQU 0 set CLIENTADDR=XXXXXXXXXXXX
if %CURDEVICE% EQU 1 set CLIENTADDR=XXXXXXXXXXXX
rem Convert channel designations to tuning commands
Pir8Man wrote:billrobpv: this thread is about dual Colossus tuners. dont hijack other threads!
mceguy, sounds like you have done everything to tell windows that there a seond tuner, but you have not informed Media Center. Re-run setup from inside Media Center and it should find the second new tuner.
michelle wrote:I am running into the same problem as mceguy. I have 2 of everything in my device manager except for the hd pvr tuner device. When I run the devcon.exe - it says failed, but I do have the Driver49 folder. Every time I check both devices in the Hauppauce MCE utlity and reboot - it unchecks one of them so WMC never sees two tuners. I have been through this thread several times and don't think I'm missing anything, but I must be! How to I get that second checkmark to stay?
michelle wrote:I got the batch file from Hauppauge support today, but have yet to try it out.
Here is the link https://drive.google.com/file/d/0B2QyvG ... sp=sharing
michelle wrote:SUCCESS!!! Finally I got it all working. I decided to give it one last shot, so I ran the hcwclear tool to start from scratch. I followed mceguy's steps above and it worked like a charm. I also had to clear my database otherwise WMC would crash during scanning channels - instructions here: http://forums.techarena.in/operating-sy ... ost5347109. Restored my recordings schedule instructions here: http://www.hack7mc.com/2009/03/backup-a ... edule.html - and checked ip channel changing and everything is well.
I hope this helps someone and that I don't have to do again anytime soon!!
You have two H24 units that run older SHEF version. You don't have all the limitations I had to face with genie clients. Your solution is here : https://sites.google.com/site/dtvipcontrol/
then use these instructions: http://forums.directv.com/message/11208644#11208644
and you should be in business.
Users browsing this forum: No registered users and 3 guests