I've tried searching the forums and I can't seem to find an answer. So I'll start a new question.
I currently have a setup with a Hauppauge WinTV-HVR-2255 card in it (2 tuners).
I'd like to swap that tuner out for a Hauppauge WinTV-quadHD card with 4 tuners.
Can I just swap them out without doing anything in WMC? Do I need to just rescan in WMC? Or do I need to do a clean slate with WMC and set it all up again? Or some combination of that?
Thanks
Tuner change
-
- Posts: 723
- Joined: Mon Nov 05, 2012 8:05 pm
- Location: Longmont, CO
- HTPC Specs:
I did that exact same change. You will need to re-run TV tuner setup in WMC to have WMC recognize the new tuner card.
-
- Posts: 26
- Joined: Fri Jul 17, 2015 3:44 am
- Location:
- HTPC Specs:
Did you have to change your EPG setup?
-
- Posts: 723
- Joined: Mon Nov 05, 2012 8:05 pm
- Location: Longmont, CO
- HTPC Specs:
I use EPG123 so I went thru the normal setup of an OTA tuner with EPG123. I.e. scan for channels, add missing VHF channels, etc. I also use
MCLXL and all my logos were still there. You will lose your favorite lineups though. Won't lose scheduled recordings or series though.
I would recommend imaging your disk before a change like this so you can go back easily.
MCLXL and all my logos were still there. You will lose your favorite lineups though. Won't lose scheduled recordings or series though.
I would recommend imaging your disk before a change like this so you can go back easily.
-
- Posts: 26
- Joined: Fri Jul 17, 2015 3:44 am
- Location:
- HTPC Specs:
Thanks for the input.
I use EPG123 as well.
Thanks.
I use EPG123 as well.
Thanks.